Posted August 15 (edited) Mining a tunnel from west to east. open a tile. The tile to the east is flat on the north side and 1 slope up on the south side. Attempting to mine the floor in the south east corner (to flatten the tile) gives the message (The Iron vein is in the way.) The next tile to the east is an iron vein. If the next tile to the east is a rock tile, you get the message (The Cave wall is in the way.) A workaround is to use the flatten command and also to back up one tile and use the level command which will lower the high corner and successfully flatten the tile. Both these methods seem to work. Definitely something wrong that you cant just mine down that corner though. Edited August 15 by Manachan Share this post Link to post Share on other sites
Posted August 15 Thanks for the report, sounds like it's the same issue reported here. The team are working on a fix! Share this post Link to post Share on other sites
Posted August 16 Had the same issues as well, except it was cave all in the way. So wasnt sure why cant mine down in the corner. Note there is no reinforced flood nearby. Share this post Link to post Share on other sites
Posted August 16 Had this issue with se corners, mining the south tile out allowed me to mine the corner afterwards. Share this post Link to post Share on other sites
