Sign in to follow this  
Delone

UI scaling is not repositioning the area you need to click on toobelts when set vertical

Recommended Posts

After scaling the UI to 80%, I have noticed that if  you set your toolbelt to vertical, the position of the area you click on the belt is not being scaled to fit with the smaller redrawn toolbelt. For example, by the time I get to the 4th slot, I need to click in the middle of slot 5 to activate slot 4, with the error distance increasing the further along the toolbelt you go.  

Share this post


Link to post
Share on other sites

Thank you for reporting this, it has been added to the list

Share this post


Link to post
Share on other sites

This is not just with the UI scaling. It has been off by almost a whole slot since the UI came out. Forum post in bugs have been made.

Share this post


Link to post
Share on other sites

I was wondering if there is any update regarding this issue? I am having this issue as well, it seems to work fine in horizontal at 80% UI scaling but vertically you have to adjust your cursor in either the small or large sized toolbelt.

 

Thank you

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this