Sign in to follow this  
ClericGunem

Small size toolbelt is out of sync in UI

Recommended Posts

When toolbelt in in vertical orientation the further one goes down the belt the more skewed the image mapping seems to be.  Below the lines are approximately where my mouse is over the scissors and the hatchet at the bottom is about 1 slot off the bottom of the graphic

 

PqJXX7I.png

 

 

 

  • Like 1

Share this post


Link to post
Share on other sites

https://prnt.sc/vvbavr

 

You can't see my mount pointer, but the tip of my mouse is actually on the bottom edge of that toolbelt.  If I want to drag something into the bottom slot of that belt, I have to drop it about a quarter inch below the belt.

Share this post


Link to post
Share on other sites

Merged Wurmhole's thread with Cleric's thread, as same topic. 

Share this post


Link to post
Share on other sites

Same issue here on vertical tool belt. off by about a half slot on large toolbelt.

Share this post


Link to post
Share on other sites

update

 c54116d35f386e79b17108b07981ae14.png

 

I guess this does fix it but 100% scale looks god awful.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this