Posted November 18, 2018 I was thinking it would be great if we could have a new wall type - fireplace. Do one for each masonry type. The crude drawing shows a top down view of a regular wall and below that a fireplace wall, which is extra thick. There would also need to be a new Chimney Wall, to go along with it and finally, out of the top of those two wall types, would be a nice matching masonry chimney, which would extend up through any roof or floor attached right above it. This way, we can have fully functioning fireplaces that look right from the inside and outside. I am always saddened when I see beautiful houses with no chimneys and smoke going through floors, ceilings and walls. You could stack fireplaces on top of each other in a multi story house and all pop out the chimney at the top. It would look great, because they are now matching masonry, to your building design. True, they won't be as flexible in positioning as the current fireplace, but you won't die from smoke inhalation either. 1 Share this post Link to post Share on other sites
Posted November 18, 2018 +1. Would also love some way to do this from within a mine to the surface (I has smokestacks poking out of the ground! ). 1 Share this post Link to post Share on other sites
Posted November 19, 2018 +1 And fireplaces that can be made of all stone types... 2 Share this post Link to post Share on other sites
Posted November 23, 2018 On 11/19/2018 at 1:46 PM, Allenkey said: +1 And fireplaces that can be made of all stone types... +1 We really need more things to make with slate. Why not fireplaces? ? Share this post Link to post Share on other sites