Sign in to follow this  
Steveleeb

[Fixed] Level lower ceiling - You cannot reach the ceiling

Recommended Posts

The work; hZXu20e.jpg

Ceiling - The ridge is to the north of the longhouse. I wished to level it by standing on the building.
 

VWDnCql.jpg

So i tried.
It's telling me i can't reach the ceiling. its north west tip is the north west from this perspective.
that corner, is at the bottom of a slope that goes into water.
I thought maybe it's checking the height beneath the NW corner, although I'm 70 slopes above it. (45 slope + 2nd floor house)
It's clearly lower than i am so why am i getting the ` You cannot reach the ceiling.` error?

This is Fablecrafter's project, it has me down below and shydow up above. This error represents an impasse.

 

  • Like 1

Share this post


Link to post
Share on other sites

Can you give me the server name, the deed name and the building name?  I'll see if a GM or Dev can take a look and recreate on test.

Share this post


Link to post
Share on other sites

Deliverance
Fabled Halls
ceiling access

Edited by Steveleeb

Share this post


Link to post
Share on other sites

bump
is this a north west corner issue and is there any hope to be had?
ty

Share this post


Link to post
Share on other sites

I took a look at the issue but will have to recreated it on test unless I can get a dev to read my scribbles and figure out what it may be.

Share this post


Link to post
Share on other sites

Looking at the pictures, a few more would help but I would say finish the longhouse, add the ceiling to it and then level that ridge of rock from the second floor.

 

Also try standing right on the edge of the floor, and if the ceilings are all flat above the longhouse try leveling that section from a adjacent tile on either side, sometimes a different angle is all you need to get it done.

 

One more thing to try is using keybinds while looking directly at that tile.

Edited by JakeRivers

Share this post


Link to post
Share on other sites

The longhouse is built, the wide shot was taken days before the ceiling shot.
The ceiling shot was taken from atop the longhouse.
I tried keybinds and select bar instead of right click, same result.
I tried standing on the edge and levelling, same result.
I tried moving a touch closer so i could flatten it instead, the client nudged me off the 2nd floor, onto the slope before the error message had a chance to occur.
I tried flattening from the 1st floor (ground floor) 45 slope, (in front of building) same error.
I tried levelling from the ground floor building tile, same error.
 

26 minutes ago, Alectrys said:

I took a look at the issue but will have to recreated it on test unless I can get a dev to read my scribbles and figure out what it may be.

I'm pretty sure it's a north west corner issue.

Edited by Steveleeb

Share this post


Link to post
Share on other sites
On 8/22/2017 at 1:05 PM, Steveleeb said:

bump
is this a north west corner issue and is there any hope to be had?
ty

 

Should be fixed next update.  Thanks for your details.

  • Like 3

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this