Search the Community
Showing results for tags 'designate'.
Found 1 result
Hey all, I built a 4x4 building with a 2x2 open middle. I finalized the writ and started to designate the walls . First is surrounded the the outer ring with slab and the inner 4 tiles with slab as well. Naturally i began to add 1 brick and 1 mortar to just start all the walls. I was going around from inside the walls (like a long square tunnel ) starting all arches on all inner and outer walls. everything was working fine until i hit the 2 outer walls on the west side (the the 2 middle of the 4 outer walls on this one side). every wall but these to went normally ,However there two will not allow me to designate them to any type of building material or style. All I get is the "refreshing" indicator on the bottom of the building window when you right click an wall plan. I hope this is fixable. Thanks all Monctonclown (Deli)